*** Restricting New Posts to SD Premium Members ONLY *** (09 May 2025)

Just made a new account? Can't post? Click above.

Help us help you. By posting the year, make, model and engine near the beginning of your help request, followed by the symptoms (no start, high idle, misfire etc.) Along with any prevalent Diagnostic Trouble Codes, aka DTCs, other forum members will be able to help you get to a solution more quickly and easily!

ABS sensors parameters

  • derekoliveira
  • derekoliveira's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
More
7 months 2 weeks ago #81612 by derekoliveira
ABS sensors parameters was created by derekoliveira
My diagnostic device reports 0.74km/h on all 4 abs sensors with the car parked even though it has no fault code, why or what it can be? In this case I am trying to diagnose why 4WD does not drive the rear wheels of a manual transmission Mitsubishi Outlander 2008.

Please Log in or Create an account to join the conversation.

  • Noah
  • Noah's Avatar
  • Offline
  • Moderator
  • Moderator
  • Give code definitions with numbers!
More
7 months 2 weeks ago #82108 by Noah
Replied by Noah on topic ABS sensors parameters
I am not very experienced with that generation Mitsubishi, but from experience it is not entirely unprecedented for the scan tool to report wheel speed when the vehicle is stationary on SOME brands.
General Motors vehicles from the early 2000's report around 3mph on each sensor not moving
"Ground cannot be checked with a 10mm socket"

Please Log in or Create an account to join the conversation.

  • derekoliveira
  • derekoliveira's Avatar Topic Author
  • Offline
  • Senior Member
  • Senior Member
More
7 months 2 weeks ago #82250 by derekoliveira
Replied by derekoliveira on topic ABS sensors parameters
Thank you for reply. When have a chance I will check with delphi scan tool.

Please Log in or Create an account to join the conversation.

Time to create page: 0.311 seconds